LPCB fire alarm systemTCZS5274 detector remote indicator (hereinafter referred to as the remote indicator) is mainly used in the fire alarm system requiring the bus connection, and can be used with the JTY-GM-TC5161 photoelectric smoke detector....
It is mainly used to connect fire-protection linkage equipment that needs to be controlled by fire alarm control panel, such as smoke exhaust valve, air supply valve, fire damper, etc., and can receive the action response signal of the equipment....
Input Voltage：AC220V
Rated DC Output：DC27V/30A
Working Mode：Integrated with JB-TG-TC5000/JB-LT-TC5200
Communication Interface：RS 485
Operating Environment：Temperature: -10°C～+50°C;Relative Humidity: ≤95% (40±2℃)
Dimension：482mm×282mm×88.5mm...
TCMK5265 input/output module (hereinafter referred to as module) is a new loop powered developed by Tiancheng company. It is mainly used to connect the fire control linkage equipment which needs to be controlled by fire alarm controller. The field...
In the contact encoding method, the device to be encoded can be encoded only by leaning on the stylus protruding from the encoder, which simplifies the encoding steps, shortens the encoding time and reduces the work intensity. The encoder can...
1. Base of the detector is shown below. There are 2 conductor pieces with terminals on the base. Detector' 5 loop should be respectively connected with
two terminals (non-polarized) After the base is fixed firmly, rotate the bottom of detector and...
TCSG5228F Conventional Sounder Strobe adopts 2 wires (24V power). It is mainly installed in public places. It generates a kind of optical and visual alarm used to warn people in field when fire occurs. With plug-in structure, reliable performance,...
Open installation applied for the module. Insert mode for installation between base and module. When installing, pull down the module, lead the wire through wiring hole, connect it with terminal and push the module onto the base. The mounting hole...
